DigiDesign PRE Specifikace stáhnout pdf (Strana 104)

D-Command Guide98

Setting D-Command Meters for Different Reference Levels

The Pro Tools Reference Level meter preference lets you change the D-Command meter display to help monitor program material

with respect to different reference levels.

At each setting except 0 dB, a single LED lights continuously across the meter bridge at a fixed point to indicate that reference

level. You can then compare the peaks of the program material to the indicated level.

The following reference level settings are available:

0dB This is the normal setting used for referencing material to a 0 dB (full code) reference level.

–14 dB This reference level setting lights a single LED at –14 dB across the meter bridge.

–18 dB This reference level setting lights a single LED at –18 dB across the meter bridge.

–20 dB This reference level setting lights a single LED at –20 dB across the meter bridge.

To set a D-Command meter reference level:

1 In the Soft Keys section, press the Meter switch.

2 Press the Soft Key that corresponds to “RefLvl” to cycle among the meter reference level settings.

3 Press the Meter switch to exit.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 139 140

Žádné komentáře

DigiDesign PRE Specifikace Strana 104